IsuzuPup.com

If you hit and knocked the wire off, you probably damaged sensor too. As cheap as they are, get a new one and swap it out.

Welcome! We'd love to see photos

I think there's a vent somewhere on the transmission also. It's plastic, if memory serves me right. It could be clogged and causing internal pressure

I am trying to track down the reason this fuse keeps blowing. I don't know the the location of the regulator or how it works, but I do know that when its fuse is blown, the IP does not work. If I remember correctly, I had this same issue many years ago. I hit a bump in a parking lot and the truck j...

The brake calipers and rotors are probably different from 83 to 84. The master cyl is also different but you can probably make it work

Welcome!

On this injection pump there's only 1 wire to the fuel solenoid. If you spot a device on the injection pump with 2 wires, it might be a tach sensor.

I found the problem. The 15amp Regulator fuse in the fuse box was blown. Why it was blown, I don't know and that may prove to be another problem. But with a new 15amp fuse, it fired right up. I once had an 85 pup that began to blow that fuse when i pushed the clutch pedal in. The wiring harness und...

Where is this relative to the IP? On the c223 diesel, it screws into the top of the injection pump. When energized, it opens up the flow of fuel from the filter. De-energized, a little spring pushes a rod down shutting off the fuel. There should be, if I remember correctly, 1 wire coming off the fu...

Another possibility is that the timing belt broke, unless you've already without a doubt ruled that out.

Welcome!

It seems like I recall that the gasket for an older S10 would work but would need the length trimmed and seamed together with maybe a butyl rubber adhesive or something.

Poquosonboy wrote: ↑Wed Oct 23, 2024 4:40 pm I messaged jerry he has them, thanks for the help. Also message JLEMOND he has sold the glass business and told me to try a local glass company for the sliding rear window runner

Do you mean Mark? (Arrowmntdiesel)

Thank you, I just emailed him, hopefully I'll get some good news If you do get a new line from jerry, he provides new washer seals for the banjo fittings. Copper or aluminum. If you find a shop that'll make a hose for you using your existing banjo fittings, locate some new washers and replace the o...

Nice truck. Welcome to the forum. We used to have a member CharlieB with a similar truck. He lived in sanford, nc