Page 1 of 1

2.2 Glow Circuit updated

Posted: Sat Nov 24, 2018 10:55 am
by Halden
Not perfect, let me know what's wrong. This is not a representation of the actual physical layout.

Re: 2.2 Glow Circuit updated...again

Posted: Tue Dec 11, 2018 1:59 pm
by Halden
Discovered I could edit and make my own symbols. So I changed the male and female single pin connectors. I "stole" Navistar/International's symbol...

Re: 2.2 Glow Circuit updated

Posted: Tue Dec 11, 2018 9:43 pm
by JoeIsuzu
Halden, what are you using to create these? They look good. Maybe I can figure out why my fast idle circuit pops fuses. ;)

Jack

Re: 2.2 Glow Circuit updated

Posted: Wed Dec 12, 2018 7:54 am
by Halden
I am using a free program called TinyCad. I'm currently working on the lighting schematic. But the fast idle should be fairly easy. Have you disconnected just the fast idle and it no longer pops?

Re: 2.2 Glow Circuit updated

Posted: Wed Dec 12, 2018 11:35 am
by JoeIsuzu
Halden wrote:I am using a free program called TinyCad. I'm currently working on the lighting schematic. But the fast idle should be fairly easy. Have you disconnected just the fast idle and it no longer pops?

I didn't mean to go off topic here. That's been low priority, so I'll post a new topic when I'm ready to tackle it.

Thanks.
Jackie