Page 1 of 1

Switch/ Phone charger mount.

Posted: Mon Mar 19, 2018 6:13 pm
by Skropeling
My Pup had a hole in the bottom center of the dash, by best guess would say that it was for an ash try of some sort. Anyway, I didn't like the way it looked, so I designed and 3D printed a mount that has a gap for a few USB ports, as well as a few switches for potential upgrades. I only have 1 out of 3 installed right now, but I have ideas for the others. Just something I did that others might find interesting. This is the right page to post these kind of things on right?
Note, the cigarette lighter above the new one doesn't work right now, But I do want to replace it for double the power!