gear "shift stick" upgrade

Whether it's up high or draggin', this is the place to discuss anything related to body and suspension modifications for street or offroad use.
southernal
Regular Member
Posts: 26
Joined: Tue Jun 18, 2013 3:40 am
Location: south island New Zealand

gear "shift stick" upgrade

Postby southernal » Fri Dec 06, 2013 6:30 pm

ok all heres a little upgrade I did - I must have been a little bored - but it was fun and looks ok .. better than the original "toothpick" shift ..

what I started with
[img]C:\Users\Al\Videos\Pictures\2013-10-25[/img]


then in place ,,
[img]C:\Users\Al\Videos\Pictures\2013-10-25[/img]

the shift stick has a 1/2inch piece of stainless tubing , that I slid over the top, standard 8 ball , and an alloy floor boot surround carefully trimmed out of 1.6mm aluminium

I have a 2ft shift that ive built and may chuck that on for fun a bit later... but not all practical....

User avatar
JoeIsuzu
Site Admin
Posts: 20285
Joined: Thu Aug 19, 2004 9:11 am
Location: Germantown (next to Elvistown), TN
Isuzu vehicle(s): Original owner, '83 LS Diesel, 5-spd, 2wd, Long Bed, restoration in progress!

Re: gear "shift stick" upgrade

Postby JoeIsuzu » Fri Dec 06, 2013 8:02 pm

We can't see the images, because they're on your computer. Use the "attachment" section when creating your post, and upload the photos.

Jack

southernal
Regular Member
Posts: 26
Joined: Tue Jun 18, 2013 3:40 am
Location: south island New Zealand

Re: gear "shift stick" upgrade

Postby southernal » Sat Dec 07, 2013 2:45 am

oops !! thanks for that , I did wonder what happened :) top picture is the finished article,, ( took a motor trans swap !!) 2nd pic is what I started with ..
Attachments
028.jpg
014.jpg